1-1/4" PVC Push Point Compression Points The push cap is attached

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

This part is made of stainless steel and is used to insert a - 2" "k" or "L" wall copper pipe into the ground after the initial hole is opened with the compression point

3) The connector with the attached pipe or conduit is lowered into the exit pit and the opposite end is connected to the male thread of the shaft without having to turn either the pipe or the shafts

The actual diameter of this part is 2" in

It should be 5/8 of an inch long

1-1/4" PVC Push Point Compression Points The push cap is attachedThis part is used to insert a 1 1 4" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap. The Push Point will have the same as the outside diameter of the pipe itself. After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point. As it proceeds, roots or