1-1/4" PVC Push Cap Compression Points 2” diameter holes

2” diameter holes

This part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole

This particular point is the Largest point that we sell

As it advances It will chase the hole and push back out of the way any roots

NOTE: An Idea is to use an old

1-1/4" PVC Push Cap Compression Points 2” diameter holesThe push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed. The push point is connected to the front or leading end of the pipe and the push cap is inserted into the bell housing on the opposite end of the same pipe, or If there is no bell housing then a coupling must be glued onto the pipe and the part inserted into the coupling. Once in place, the push cap may be struck with a